Watlow 12LS Controller - Manual (Page 83)

4-50
4.7.6 EDIT EXTERNAL RESET
From this menu one of the eight digital inputs will be selected to provide an input for a external
reset of this profile while in any of the R/S operational modes. A selection of 0 will disable this
function. The same input may be assigned to more than one profile.
|-----------------|
Display: ¦ x EXTERNAL RESET¦
¦ INPUT NUMBER? d ¦
|-----------------|
The ? is flashing.
x is the profile designator [A-L].
d is the assigned digital input number [1-8], 0 for no
assignment-external reset disabled.
YES Change digital input number assigned to this profile.
Lower display INPUT NUMBER= d
UP/DOWN Select digital input number.
ENTER Assign digital input number for the external reset function.
BACK Return to Setup Ramp/Soak Profile?
4.7.7 EDIT SEGMENT NUMBER
From this menu one of the twenty profile segments may be selected for editing. The default
number will be either the last segment edited or SEGMENT 1 if none has been edited. When
entering profile data sequentially the segment number will automatically increment to the next
segment each time this menu is entered.
|---------------|
Display: ¦ x EDIT SEGMENT¦
¦ NUMBER ? yy ¦
|---------------|
The ? flashes.
x is the profile designator [A-L].
yy is the default segment number [1-20].
YES Select a segment other than the default segment for editing.
Lower display SEG = xx
UP/DOWN Select segment number.
ENTER Open selected segment for editing. Display advances to Edit Segment Time.
BACK Return to SETUP R/S PROFILE? prompt.