Watlow 12LS Controller - Manual (Page 71)

4-38
4.6.3 PROFILE STATUS DISPLAY
Whether in the TIME display, the CYCLE COUNT display or the PROFILE OPERATION menu,
the upper line of the display will always show the current PROFILE STATUS. An example of this
STATUS display line follows:
Profile | Current Segment executing
Assigned ¦ and total profile segments
Loop ¦ ¦
Number | ¦ ¦ | First letter of current
|----------------| loop status
¦05 A SEG01/07 R ¦
¦ ¦
|----------------|
Refer to TABLE 4-1 for description of the loop status symbols.
|-------------------------------------|
¦ Table 4.1 Loop Status Symbols ¦
|-------------------------------------¦
¦ Symbol ¦ Description ¦
|-------------------------------------¦
¦ S ¦ Loop is ready to Start ¦
|-------------------------------------¦
¦ R ¦ Loop is Running ¦
|-------------------------------------¦
¦ H ¦ Loop is in Hold ¦
|-------------------------------------¦
¦ W ¦ Loop is waiting for a ¦
¦ ¦ trigger input. Time is ¦
¦ ¦ stopped. ¦
|-------------------------------------¦
¦ T ¦ Loop has exceeded ¦
¦ ¦ tolerance limits and ¦
¦ ¦ time is stopped. ¦
|-------------------------------------|
4.6.4 PROFILE SELECTION MENU
If no profile is assigned to the loop, pressing the RAMP/SOAK key from the SINGLE LOOP
display will change the display to the PROFILE SELECTION menu. An example of this display
is:
|----------------|
¦05 ASSIGN R/S ¦
¦PROFILE ? NONE ¦
|----------------|
The 5 in the upper left corner represents the loop number.
Press NO or BACK to return to SINGLE LOOP display.
Press YES to select a profile for assignment to this loop. The "?" will change to "=".