Watlow 12LS Controller - Manual (Page 57)

4-24
4.5.3.1 PROPORTIONAL BAND
The first selection for each output allows programming of the proportional band. The display bottom line appears as :
|----------------|
¦ ¦
¦ PB ? xxxx ¦
|----------------|
Press YES to select the menu or NO to advance to the next menu.
Press UP and DOWN to set the proportional band in engineering units.
Press ENTER to store the value or BACK to return to the SETUP LOOP CONTROL PARAMS main menu prompt.
4.5.3.2 INTEGRAL CONSTANT
This menu allows programming of the integral constant. The bottom line of the display will appear as :
|----------------|
¦ ¦
¦ TI ? xxxx ¦
|----------------|
Press YES to select the menu or NO to advance to the next menu.
Press UP and DOWN to set the integral constant (or reset) between 0 (OFF) and 1024 seconds.
Press ENTER to store the value or BACK to return to the SETUP LOOP CONTROL PARAMS main menu prompt.
4.5.3.3 DERIVATIVE CONSTANT
This menu allows programming of the derivative constant. The bottom line of the display will appear as :
|----------------|
¦ ¦
¦ TD ? xxx ¦
|----------------|
Press YES to select the menu or NO to advance to the next menu.
Press UP and DOWN to set the derivative constant between 0 (OFF) and 255 seconds.
Press ENTER to store the value or BACK to return to the SETUP LOOP CONTROL PARAMS main menu prompt.