Watlow 12LS Controller - Manual (Page 44)

4-11
4.5 SETUP MENUS
To change any other of the controller settings select the loop desired and from the SINGLE LOOP display enter the
password key sequence by pressing these three keys in this order :
|-----| |-----| |-----|
¦ENTER¦ ¦ALARM¦ ¦CHNG ¦
¦ ¦-->¦ ACK ¦-->¦ SP ¦
|-----| |-----| |-----|
In this way, the operational menus can be made available to operators while supervisors and other approved personnel
familiar with the password sequence can access the setup menus. The display will initially show:
|----------------|
¦ SETUP GLOBAL ¦
¦ PARAMETERS ? ¦
|----------------|
Press NO to cycle through the detailed menu main headings as follows. After the six other menu headings the display
will return to the GLOBAL PARAMETERS menu.
|----------------| |----------------| |----------------|
¦ SETUP LOOP LL ¦ ¦ SETUP LOOP LL ¦ ¦ SETUP LOOP LL ¦
¦ INPUT ? ¦-->¦CONTROL PARAMS ?¦-->¦ OUTPUTS ? ¦-|
|----------------| |----------------| |----------------| ¦
|----------------------------------------------------|
¦ |--------------------|
|----------------| ¦ |----------------| ¦ |----------------|
¦ SETUP LOOP LL ¦-| ¦SETUP RAMP/SOAK ¦ |>¦ MANUAL I/O ¦
¦ ALARMS ? ¦-->¦PROFILE ? ¦-->¦ TEST ? ¦-|
|----------------| |----------------| |----------------| ¦
|----------------------------------------------------|
|----------------|
¦ SETUP GLOBAL ¦
¦ PARAMETERS ? ¦
|----------------|
Press YES at any of these main menu headings to enter that menu and gain access to the associated sub-menus to
change any parameters as outlined in the following sections. The main menu heading for setting up ramp and soak
profiles will not appear unless the RAMP AND SOAK option is installed.
Each loop is set up from the front panel or through the serial interface with the desired operating parameters. The
following loop setup diagram may be copied and used to list values prior to entry. This helps in keeping track of data
as it is entered.
If an IBM PC or compatible computer is available, ANAFAZE software can be used for parameter entry and storage.