Watlow 12LS Controller - Manual (Page 49)

4-16
4.5.1.6 POWER UP OUTPUT STATUS
This menu is used to configure the initial power-up state of the control outputs. The controller will either initialize the
outputs to OFF or to the last output state as it was left stored in memory. If OFF is chosen all control outputs are
initially set to MANUAL mode at 0% output level. If MEMORY is chosen the outputs are restored to their condition
when power was removed.
|-----------------------------------------------------|
¦ WARNING! -- SET SAFE START-UP CONDITIONS ¦
|-----------------------------------------------------¦
¦ Do NOT use MEMORY startup if there is any chance ¦
¦the process could start in an unsafe state. ¦
|-----------------------------------------------------|
The display will appear as:
|----------------|
¦POWER UP OUTPUT ¦
¦STATUS ? xxx ¦
|----------------|
Press YES to select the menu or NO to advance to the next menu.
Press UP and DOWN to toggle the selection between OFF and MEMORY.
Press ENTER to store the new power up output status or press BACK to return to the SETUP GLOBAL
PARAMETERS main menu prompt.
4.5.1.7 CONTROLLER ADDRESS
This menu is used to set the 12LS controller address. This box address is used for communications and each 12LS in a
system must have a different address. Begin with address 1 for the first controller and assign each subsequent
controller the next higher address. The default address is, of course, 1. The display will appear as :
|----------------|
¦ CONTROLLER ¦
¦ ADDRESS ? xx ¦
|----------------|
Press YES to select the menu or NO to advance to the next menu.
Press UP and DOWN to increment or decrement the address from 1 to 32.
Press ENTER to store the controller address or press BACK to return to the SETUP GLOBAL PARAMETERS main
menu prompt.