Watlow 12LS Controller - Manual (Page 46)

4-13
|-----------------------------------------------------|
¦ NOTE: Unless otherwise specified, in all examples ¦
¦of menu displays in the following discussions about ¦
¦editing and programming, the question mark (?) would ¦
¦ be blinking and the multiple x's used represent the ¦
¦ data or choice to be edited. When a menu is selected¦
¦ the x's would show the current data setting and the ¦
¦ question mark (?) would become an equal sign (=) ¦
|-----------------------------------------------------|
4.5.1 SETUP GLOBAL PARAMETERS?
Answer YES at this prompt to access editing menus for global system parameters. This group of menus includes those
that allow the user to :
o Save memory to a job number
o Restore a job number to memory
o Set the alarm delay
o Select the global time base
o Lock out panel editing
o Select output state on power-up
o Set the controller communications address
o Set the communications error checking method
o Set the communications baud rate
o Set the AC line frequency
o Check the PROM version and date
4.5.1.1 STORING JOB SETUP
The current operating parameters may be stored in battery-backed memory by saving them to one of 8 job files.
Information for all 12 channels is saved in each job file and includes :
o Setpoints
o Output percentage
- both heatand cool output values
o Channel status (auto, manual, etc.)
o Alarminformation
- status
- setpoints
- output assignments
o Assigned ramp and soak profile if in ramp/soak mode