Watlow 12LS Controller - Manual (Page 64)

4-31
Press ENTER to store the output assignment or press BACK to return to the SETUP LOOP ALARMS main menu
prompt.
4.5.5.7 LOW DEVIATION ALARM OUTPUT ASSIGNMENT
This menu is used to assign a digital output to be activated in the event of a low deviation alarm. Any of the 9 available
digital outputs may be used or the output function may be turned OFF. The display appears as:
|----------------|
¦LL LO DEV. ALARM¦
¦OUTPUT NR ? xx ¦
|----------------|
Press YES to select the menu or NO to advance to the next menu.
Press UP and DOWN to step through the available output assignment choices.
Press ENTER to store the output assignment or press BACK to return to the SETUP LOOP ALARMS main menu
prompt.
4.5.5.8 LOW PROCESS ALARM SETPOINT
This menu is used to set the point within the scaled sensor range at which the low process alarm is activated. The
display appears as :
|----------------|
¦LL LO PROC ALARM¦
¦SETPOINT ? xxxx¦
|----------------|
Press YES to select the menu or NO to advance to the next menu.
Press UP and DOWN to adjust the low process alarm setpoint.
Press ENTER to store the setpoint or press BACK to return to the SETUP LOOP ALARMS main menu prompt.
4.5.5.9 LOW PROCESS ALARM STATUS
This menu is used to enable or disable the low process alarm check. OFF disables the alarm check, ON enables it. The
display appears as:
|----------------|
¦LL LO PROC ALARM¦
¦ STATUS ? xxx ¦
|----------------|
Press YES to select the menu or NO to advance to the next menu.
Press UP and DOWN to toggle the selection between OFF and ON.