Watlow 12LS Controller - Manual (Page 35)

4-2
|- - - - - - - - - - - - - -|
Back
|------------------| ¦ ¦ ¦
¦|----------| |----------| |----------| Any Display |----------| |--------------|
¦¦ Bar |<-->¦ Single |---->¦ Scan ¦ >------------¦ Alarm ¦ ¦ | - -¦ SETUP || ¦
¦¦ Graph ¦BACK¦ Loop ¦Enter¦ Loops ¦ On Alarm ¦ Display ¦ ¦ RAMP AND SOAK¦
¦|----------| |----------|Enter|----------| |----------| ¦ ¦ |--------------|¦ ¦
¦ ¦|--------| ¦|--------| ¦
¦ |¦ CHNG ¦ |¦ ALARM ¦ ¦ ¦ |-Profile # ¦ ¦
¦ ¦¦ SP ¦ ¦ ACK ¦ |-Copy Prof.
¦ ¦|--------| |--------| ¦ ¦ |-Tol. Time ¦ ¦
¦ ¦|--------| | Return |-Ready Sp
¦ |¦ MAN |-Set % Output ¦ ¦ |-Ready Events ¦ ¦
Pass ¦¦ AUTO ¦ |-Segment #
Key ¦|--------| ¦ ¦ |-Time ¦ ¦
Sequence |- -¦- - - - - - - - - - - - - - - - - - --| |-Setpoint
¦ ¦ ¦|--------| ¦ ¦ ¦ |-Events ¦ ¦
ENTER |¦ RAMP |-Select Profile |-Triggers
ALARM ACK ¦ ¦ SOAK |-Run, Hold, Continue, Reset ¦ ¦ ¦ |-Tolerance ¦ ¦
CHNG SP |--------| |-Last Segment
¦ ¦ |----View Profile Status ¦ ¦ ¦ |-Cycles ¦ ¦
¦ |----View Time Remaining
¦ ¦ |----View Cycle Counter ¦ ¦ ¦ (optional) ¦ ¦
¦ (optional) |- - - --- - - - - - - - -|
¦ |- - - - - - - - - - - - - - - - - - - - --| ¦ ¦
¦ Back Back Back Back Back Back
¦ ¦ ¦ ¦ ¦ ¦ ¦ ¦ ¦
|--------------| |--------------| |--------------| |--------------| |--------------| |--------------|
¦SETUP GLOBAL ¦ ¦SETUP LOOP XX |-¦SETUP LOOP XX |--¦SETUP LOOP XX |--¦SETUP LOOP XX |--¦ MANUAL I/O ¦
¦PARAMETERS ¦ ¦INPUT ¦ ¦CONTROL PARAMS¦ ¦OUTPUTS ¦ ¦ALARMS ¦ ¦ TEST ¦
|--------------| |--------------| |--------------| |--------------| |--------------| |--------------|
¦ ¦ ¦ ¦ ¦ ¦
|-Save To Job# |-Type |-PB-Heat |-Type-Heat |-Hi Process |-Digital Inputs
|-Load From Job# | Units |-TI-Heat ¦|CycleTime-Heat |-HP On/Off |-Digital Outputs
|-Alarm Delay |-Units |-TD-Heat |-Rev/Dir-Heat |-HP Out #
|-R/S Time |-Scaling |-FIL-Heat |-Output Limit |-Deviation
|-Panel Lock |-PB-Cool |-Limit Time |-Dev On/Off
|-Power Up State |-TI-Cool |-Type-Cool |-HD Out #
|-Ctlr Address |-TD-Cool ¦|CycleTime-Cool |-LD Out #
|-Comm Err Chk |-FIL-Cool |-Rev/Dir-Cool |-Low Process
|-Baud Rate |-Heat/Cool |-Output Limit |-LP On/Off
|-AC Frequency Spread |-Limit Time |-LP Out #
|-PROM Version |-Deadband
Figure 4-1. DISPLAY FLOWCHART