Proface APL3000B - Node Box PC - Manual (Page 70)

Chapter 4 System Setup
4-11
„ I/O Device Configuration
Point the cursor to the [I/O Device Configuration] on the [Advanced] screen and press the [Enter] Key, so that
the following screen will be displayed.
On board Serial Port 1
Specifies an enabled/disabled state for the COM1. Select from [Disabled] or [Enabled]. The factory default
setting is [Enabled]. In addition, the factory default setting for Base I/O Address is [3F8], and for Interrupt is
[IRQ 4].
On board Serial Port 2
Specifies an enabled/disabled state for the COM2. Select from [Disabled] or [Enabled]. The factory default
setting is [Enabled]. In addition, the factory default setting for Base I/O Address is [2F8], and for Interrupt is
[IRQ 3]. The COM2 is used in the system.