Proface APL3000B - Node Box PC - Manual (Page 67)

PS-3650A / PS-3651A User Manual
4-8
QuickBoot Mode
Specifies whether the system boot-up should be “QuickBoot mode”. When the choice is [Disabled], it will
execute a system test at the system starting-up. The factory default setting is [Enabled].
Extended Memory Testing
Specifies whether a test for the Extended Memory needs to be executed at the system starting-up. The test
types are listed below. The factory default setting is [Just Zero it].
[Normal] Normal test
[Just Zero it] Simple test
[None] No test
Show CMOS Checksum Error
Specifies whether you need to display the errors in case CMOS Checksum Error occurs. The choice
is [Enabled] or [Disabled]. The factory default setting is [Disabled].
Power On Delay
Specify whether to set standby time before the system starts up. Select [Enabled] or [Disabled]. When
[Enabled] is selected, the system waits for 4 seconds before start-up. The factory default setting is [Disabled].
• When the unit is started up with a USB device such as connecting USB memory, the following
may occur depending on the device.
• It takes about one minute before the OS starts up.
• The PS-A does not recognize the USB device.
These problems may be solved by setting [Power On Delay] to [Enable].