Proface APL3000B - Node Box PC - Manual (Page 54)

Chapter 3 Hardware Installation
3-17
3.3.3 PCMCIA (PC Card) Installation/Removal
(1) Slacken a screw of PCMCIA slot on the side of the PS-A unit to move the cover.
(2) Press the eject button twice to remove the PC Card from the PCMCIA connector. (Pressing the eject but-
ton once causes its tip to come out. Pressing the eject button the second ejects the PC Card from the
PCMCIA slot.)
(3) Place back the PCMCIA slot cover and tighten a screw.
To install a PC Card Type III, unscrew the PCMCIA slot cover’s screw and remove the cover as shown below.
• When using a PC Card with a cable attached, Pro-face recommends you use a clamp or
other type of device to prevent vibration from possibly dislodging the cable.
• When energizing to PS-A, be sure to stop the PS-A unit PC Card’s driver prior to remov-
ing the PC Card. A failure to stop this driver may result in damage to either the PC Card,
the PC Card’s data, or may cause Windows
®
to hang up. For information on the proce-
dure for stopping the PC Card’s driver, please refer to your OS’ User Manual.
• Install the PC Card in the slot on the display side (A in the illustration). The slot on
the rear side (B in the illustration) does not support a PC card.
• Please keep the removed PCMCIA slot cover and screw with care.
PC Card
Eject Button
A
B