1 prior to operating the ps-a unit, 1 prior to operating the ps-a unit -2, Prior to operating the ps-a unit – Proface APL3000B - Node Box PC User Manual
Page 17: 2 1.1 prior to operating the ps-a unit
PS-3650A / PS-3651A User Manual
1-2
1.1
Prior to Operating the PS-A Unit
The following procedures are prior to use the PS-A unit.
• After hardware setup is completed, the OS must be used to create partitions and
format (initialize) the HDD before any data or applications can be saved to the
hard disk drive. For details concerning these procedures, refer to the OS
manufacturer’s instruction manual.
• Whenever you turn the PS-A unit’s power OFF, wait until the internal HDD stops
spinning (approximately 5 seconds) before turning the power ON again.
• The PS-A’s hard disk is designed for use with the Windows
®
2000, Windows
®
XP.
Other operating systems do not support this driver software, etc.
Connect the display unit and any optional devices.
Connect the PS-A unit’s power cord to AC Intercon-
nection and turn the power switch ON.
Configure the PS-A unit’s BIOS.
Install all required software. For software instal-
lation instructions, refer to the manual provided
with that product.
SEE
SEE
3.2 Wiring Precautions (page3-7)
SEE
4.1 Setup Procedures (page4-2)
Connect Peripheral Devices
Connect Power
Set Up the System
Install an OS
Install Driver
Install Required Device Drivers
Install Required Software
Install the PS-A Unit
[When PS-A has no preinstalled OS]
Install a commercial OS
in your PS-A. For how to
setup the OS, refer to
the manual provided
with the product.
[When PS-A has preinstalled OS]