Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 52)

52
(5) Insert the terminal connector, which
the I/O cable is connected to, into the
terminal block.
• The terminal connector withstands
insertion and removal more than 100
times.
18.3 MIL Connector
• Models that have MIL connector
interfaces are as follows:
„
I/O Cable Specifications
• MIL connector from Oki Electric Cable
Co., Ltd. FL20A2F0 is recommended.
18.4 Terminal Block (nonremoval)
• This terminal block is mounted to the
EXM-DMM24DRF and cannot be
removed.
„
I/O Cable Specifications
„
I/O Cable Connection
(1) Confirm that the power cord of the
unit, connected the EX module, is
unplugged from the power supply.
(2) Push in the plate next to the terminal
with a flat-blade screwdriver (size: 2.5
x 0.4 mm).
(3) The terminal opens. Insert the stripped
I/O cable. Release the flat-blade
screwdriver to allow the terminal to
clamp the I/O cable.
18.5 Wiring Precaution
• To help prevent noise and interference
problems, separate all control,
communication and power lines by
placing them in a separate ducts.
EXM-DDO16UK
EXM-DDO16TK
I/O Cable Diameter 0.08 mm
2
(28 AWG)
Cable length in
compliance with
electromagnetic
immunity
3 m (max.)
I/O Cable Diameter
0.5 to 1.0 mm
2
(20 - 18 AWG)
Cable length in
compliance with
electromagnetic
immunity
3 m (max.)
Terminal
Plate
3) Insert the
I/O cable into
the terminal.
Release the
flat-blade
screwdriver
to secure the
cable.
2) Press a
flat-blade
screwdriver
against the
plate.
Duct for I/O
Signal Lines Duct for
Control Lines Duct for
Power Lines