Maple Systems OIT Family (ASCII) - Manual (Page 5)

OIT to PC Wiring for OIT Configuration
The OIT must be configured for a particular protocol before use. The OITware 200 configu-
ration software is used to program the OIT for connection to an ASCII host. A configuration
file must be downloaded to the OIT before the OIT can be used. For detailed instructions on
installing the OITware 200 configuration software and configuring your OIT with the
OITware 200 configuration software, please refer to the OITware 200 User’s Guide. The fig-
ure, below, shows the typical OIT to PC wiring for the various OIT Family Operator Inter-
face Terminals.
4 OIT Family Operation Manual (ASCII)
1010-0088, REV02
OIT
Com2
(Rear of
OIT)
7431-0049
7431-0050A
Printer
OIT3250B
OIT4450B
OIT5400B
Port 1
PC
OIT Power
Supply
Power
Maple Systems
OIT to PC cable
(If mouse is using
Com 1, use Com2)
Port 2
Com1
-
GND+
OIT
Com2
(Rear of
OIT)
7431-0049
Printer
OIT3200B
OIT4400B
PC
OIT Power
Supply
Maple Systems
OIT to PC cable
(If mouse is using
Com 1, use Com2)
Com1
- GND+
OIT
Com2
(Rear of
OIT)
7431-0048
Printer Port 1
Power
/
PC
OIT Power
Supply
Maple Systems
OIT to PC cable
(If mouse is using
Com 1, use Com2)
Com1
- GND+
OIT3600B
7431-0050A
Port 1 Power
OIT
Com2
(Rear of
OIT)
7431-0049
Printer
PC
OIT Power
Supply Maple Systems
OIT to PC cable
(If mouse is using
Com 1, use Com2)
Com1
6030-0009
Port 1
Power
OIT3160A
OIT4160A
- GND+
Figure 1 OIT to PC Wiring Configurations