IEI Integration NANO-945GSE v2.00 - Manual (Page 22)

NANO-945GSE EPIC Motherboard
Page 22
 2 x Serial ATA (SATA) drive connectors
 2 x RS-232 serial port connectors
 1 x RS-232/422/485 serial port connector
 1 x TV Out connector
 2 x USB 2.0 connectors (supports four USB 2.0 devices)
The NANO-945GSE has the following external peripheral interface connectors on the
board rear panel.
 2 x Ethernet connectors
 1 x PS/2 connector
 1 x Serial port connector
 2 x USB connectors
 1 x VGA connector
The NANO-945GSE has the following on-board jumpers:
 AT Power Mode Setting
 Clear CMOS
 CF card setup
 LVDS1 Voltage Selection
 LVDS1 and LVDS2 Panel Resolution Selection
 LVDS2 Voltage Selection
 COM2 Port Mode setting
 PC104+ VIO Selector
1.3 Board Dimensions
The dimensions of the board are listed below:
 Length: 165 mm
 Width: 115 mm