IEI Integration KINO-DH810 - Manual (Page 30)

KINO-DH810
P a g e 18
The AT/ATX mode select switch specifies the systems power mode as AT or ATX.
AT/ATX mode select switch settings are shown in Table 3-3.
Setting Description
Short 2-3 AT Mode
Short 1-2 ATX Mode Default
Table 3-3: AT/ATX Mode Select Switch Settings
The location of the AT/ATX mode select switch is shown in Figure 3-2 below.
Figure 3-2: AT/ATX Mode Select Switch Location
3.2.2 Ba tte ry Co n n e c to r
CN La b e l: BAT1
CN Typ e : 2-pin wafer
CN Lo c a tio n : See Figure 3-3
CN P in o u ts : See Table 3-4
The battery connector is connected to the system battery. The battery provides power to
the system clock to retain the time when power is turned off.