IAI America IF - Manual (Page 14)

8
Caution in Handling
1. Do not have the settings of speed and acceleration/deceleration exceeding
the rated values.
An operation with speed and acceleration/deceleration beyond the allowable range may
cause an abnormal noise, vibration, malfunction or shortened life.
When having an interpolating operation for combined axes, set the smallest value among the
combined axes for each of speed and acceleration/deceleration settings.
2. Set the allowable load moment within the allowable range.
Use the product with the applied load moment within the allowable range.
An operation with the load beyond the allowable load moment may cause an abnormal noise,
vibration, malfunction or shortened life. If it is extreme, flaking may occur on the guide.
3. Set the overhang length within the allowable range.
Have the overhang length of the load within the allowable range. The overhang length above
the allowable range may cause vibration or abnormal noise.
4. Back and forth operation in a short distance may cause wear of grease.
Continuous back and forth operation within a distance less than 30mm may cause wear of
grease.
As a reference, have approximately 5 cycles of back and forth operation in a distance more
than 50mm in every 5,000 to 10,000 cycles to regenerate the oil film. Keep using the actuator
with the grease worn out may cause malfunction. If it is extreme, flaking may occur on the
guide.
5. Ensure use of the product in the specified conditions, environments and
ranges.
Operation out of the specified conditions could cause a drop in performance or malfunction of the
product.