Fairbanks FB2255 Series Instrument PC2255 PC Software Utility Program - Manual (Page 18)

Section 3: Serial Communication Wiring
01/13 18 51297 Rev. 1
2.9. Weight Accumulation
1. Place a weight on the Scale Platform.
2. After the weight is stable, press the B/G NET key until the display alternates
between the number of Accumulations "n" and the Accumulated weight.
3. Press the UNITS key to accept the weight, (display will momentarily indicate
“ACCEPt”, or press the B/G NET key to skip and return to the weigh screen.
4. The scale must return to “0” Gross Mode before another accumulation can
occur.
5. Repeat steps 1 through 4 for additional accumulations.
2.10. Number of Accumulations
1. Press and hold ZERO for three (3) seconds.
– The display will alternate between the Accumulated Piece Count and the
Accumulated Weight for thirty (30) seconds, then return to the Weigh
Mode.
2. Press UNITS and exit immediately to the Weigh Mode.
– Pressing the UNITS key will not clear the accumulator.
2.11. Clearing the Accumulators
1. Press and hold the BG/Net key for three (3) seconds.
– The display will indicate “Sleep” and then display the current setting.
2. Press Right Arrow key .
– “CLr.ACC” will display.
3. Press the MENU key, then the Right Arrow key to toggle the available
settings.
Available selections include the following settings.
Clr.YES (Clear the Accumulator) CLr. NO (Do not Clear the Accumulator)
4. Press ENTER to enter the selection.