Fairbanks OMEGA SERIES COUNTING SCALE - Manual (Page 18)

Section 4: User Operations
04/13 18 51278 Rev. 2
Example： ： ： ：
1. Press the keys, to enter piece weight as 0.5 lb.
2. Press and 0.5 shows on the second line.
3. The piece weight may be cleared by pressing the key if an entry error
was made. Repeat the process to correct.
4.5.2. SETUP PIECE WEIGHT BY SAMPLING (QUICK SET)
1. Put certain pieces of objects onto the scale pan.
2. In weighing mode, press the numeric and decimal keys ( , , ) to enter
the piece count.
3. Press to calculate the piece weight. The input data will be cleared in 10
seconds if is not pressed.
4. The piece weight may be cleared by pressing the key.
Example： ： ： ：
1. Place 1 lb on the scale weighing pan.
2. Press to set item number as 5. Its shows on the second line.
3. Press and the Omega Counting Scale will show the piece weight on the
second line and the item count on the third line.
4. The piece weight may be cleared by pressing the key if an entry error
was made. Repeat the process to correct.
4.5.3. SETUP PIECE WEIGHT BY SAMPLING (PLACE ITEM)
1. Make sure the piece weight is empty. The Omega Counting Scale will calculate
the piece weight by the weight added and piece count number as listed below.
2. Press , the second row of LCD shows and the third row of LCD
shows default value as 100.
3. Press the numeric and decimal keys to enter the new sampling quantity.
4. Place objects of desired piece counts on the weighing pan. The piece weight will
be calculated automatically in approximately 3 seconds or press the key
to calculate immediately.