FEC AFC1200 - Manual (Page 80)

)(& ,QF
3. IF a (save) FILE Name is entered that already exists on the (save) disk, then a "FILE
EXISTS" message will appear at the bottom of the screen. If [START] is input, the data
will be added to the existing file. If the System has been powered down since the last data
save, and the (new) file number/ cycle number combinations are the same as those on the
disk, then the disk will be overwritten with the new information.
FIG. 7-13-3 DATA file utility (DATA Select) screen operation
A. FILE FORMAT : STATISTICS FORMAT (Data collection is based on this screen setup):
3-1a. Move the cursor on the menu bar to [DATA SELECT] using the
[←] [→]
keys and
depress the
[↵]
key. The Data Select window will appear. (Refer to Fig. 7-13-3)
3-2a. Using the
[↑] [↓]
keys, move the cursor to the desired display item. As each item is
accessed, it will become highlighted. To select the item, use the
[±]
key to add or
remove the [*] symbol from the column to the left of the item list. If the [*] symbol
appears next to an item, the item will be displayed.
3-3.a After completing selection, depress the
[↵]
key and "DATA CHANGE OK Y/N?" will
appear. Select Yes or No using the
[←] [→]
keys, and depress the
[↵]
key to
finalize selection and exit from the Data Select window.
3-4a. If information is being compiled on a diskette, then first insert a formatted diskette into
the Floppy Disk Drive (FDD). Depress the [SEL] key, and the cursor will highlight the
[DRIVE] field. USE the
[←] [→]
keys to select the desired drive.
Chapter 7: System Operation
Page 7-80