FEC AFC1200 - Manual (Page 39)

)(& ,QF
Note: If changes are made to this pulldown menu setup, the System must be cycled before the
Fastening Curve will display in accordance with the new parameters.
7.4.4 DATA BASE SELECTION
4-1. To configure the Fastening Curve screen to display either a Torque / Angle or Torque
/ Time curve, mOVe the cursor on the menu bar to DATA BASE using the
[←] [→]
keys, and depress the
[↵]
key.
4-2.
THE DATA BASE pulldown menu will appear. TWo selections are available from this
menu, ANGLE BASE and TIME BASE. USE the
[←] [→]
keys to select the curve
type, and depress the
[↵]
key. The curve will display with the Torque scale on the
left, and with the Angle or Time scale, as appropriate, across the bottom.
FIG. 7-4-4 fastening curve data base selection
7.4.5 PRINT FASTENING CURVE
5-1. MOVE the cursor on the menu bar to [PRINT] using the
[←] [→]
keys, and depress
the
[↵]
key. THE FASTENING Curve screen will be printed.
Note: The keypad will be non-functional during the printing process.
Chapter 7: System Operation
Page 7-39