FEC AFC1200 - Manual (Page 63)

)(& ,QF
2-4. RS232C PORT (CH2) [SYSTEM CONFIGURATION (4)]
BAUD RATE
: 1200 BPS (2400, 4800, 9600, 19200)
the communications baud rate for this port may be set to one of five common
values.
CHARACTER : 7 BIT (8 BIT)
Character length may be set to either seven or eight bits.
PARITY : EVEN (ODD, NO PARITY)
parity may be set to odd, even, or no parity.
STOP BIT : 1 BIT(S) 2 BIT(S)
stop bits may be set to either one or two.
FIG. 7-9-2-4 system configuration (4) screen explanation
2-5. INPUT DATA FORMAT FOR RS232C PORT (CH2)
2-5a. The input data format block of the [SYSTEM CONFIGURATION (4)] screen
provides a means to configure the System for receipt of a formatted stream of data.
The input data stream may be up to 128 characters long with no more than four (4)
independent selectable blocks of data.
2-5b. This block is set up by marking each character position with an identification
code which corresponds with the [PRINT CHARACTER (DATA) INPUT] screen. The
print character input screen is used to configure the header and line format for the
[SYSTEM CONFIGURATION (1), (2), and (3)] outputs.
Chapter 7: System Operation
Page 7-63