FEC AFC1200 - Manual (Page 69)

)(& ,QF
7.9.6 SCREEN OPERATION [SYSTEM CONFIGURATION (4)]
6-1. After selecting [SYSTEM CONFIGURATION] from the menu bar, move the cursor on
the menu bar to [PAGE UP] or [PAGE DOWN] and depress the
[↵]
key until the
screen displays [SYSTEM CONFIGURATION (4)]. DEpress the [SEL] key. THe
screen will change to the set mode with the first item (BAUD RATE:) highlighted.
6-2. To change any of the four (4) preset values for [SYSTEM CONFIGURATION (4)], the
item must first be selected using the
[↑] [ ↓ ]
keys. the
[←] [→]
keys are used to
select the desired value from the available options. after each item is set the
[↵]
must be pressed to confirm the setting prior to going to another item. (Refer to
Section 7.9.2.4 screen explanation for details of available settings.)
FIG. 7-9-6a screen operation [SYSTEM CONFIGURATION (4)]
6-3. To configure the INPUT DATA FORMAT for [SYSTEM CONFIGURATION (4)], the
position in the 128 character block must first be selected using the
[↑] [ ↓ ]
and
[←]
[→]
keys. depress the
[↵]
key and the HEX DATA INPUT WINDOW will appear.
select the appropriate character and depress the
[↵]
key.
6-4 After completing all desired changes, depress the [SEL] key and the question "DATA
CHANGE OK?" will appear. Select YES or NO and depress the
[↵]
key.
Chapter 7: System Operation
Page 7-69