FEC AFC1200 - Manual (Page 15)

)(& ,QF
7.1.5 REVERSE PARAMETER SETUP
THE function of this screen is to preset the following parameters:
REVERSE SPEED [RPM] REVERSE TORQUE [TQ]
REVERSE TIME [SEC] REVERSE ANGLE [DEG]
REVERSE REVOLUTIONS [REV]
5-1
SELECT INPUT MODE
5-1a. MOVe the cursor on the menu bar to [INPUT MODE], select [REVERSE] and
depress the
[↵]
key. THe screen displayed will be the "SET PARAMETER
(REVERSE)" screen. Check the Parameter Number to ensure that the correct
number has been selected. THE screen will change to display the "SET
PARAMETER (REVERSE)" screen.
5-1b.
DEPREss the [SEL] key, and the cursor will move to the first position for
numerical entry.
FIG. 7-1-5-1 set parameter [REVERSE ]
Chapter 7: System Operation
Page 7-15