Teledyne 7600 - Infrared gas analyzer - operating manual - Manual (Page 77)

Infrared Gas Analyzer Operation
Teledyne Analytical Instruments 77
1. From the measurement screen, press the MODE key to
enter the user mode then navigate to the Parameter
Setting option. Press the ENT key to bring up the
parameter setting screen.
2. Select the Output Hold option by moving the cursor to it
using the UP and Down keys. Select it by pressing ENT.
3. “ON” or “OFF” is highlighted. If you desire to change
the state, press the UP or DOWN key to toggle between
ON and OFF. Press the ENT key to select the desired
state.
4. To change the hold value, use the SIDE key to highlight
“Current” or “Setting”. Select “Setting” by pressing the
UP or DOWN key until that option appears then press
ENT. The screen changes to the hold setting screen where
you can select the channel and hold value for that
channel.