Teledyne 7600 - Infrared gas analyzer - operating manual - Manual (Page 118)

Appendix Model 7600
Teledyne Analytical Instruments 118
A.6 Installation Requirements
• Indoor use. Select a place where the equipment does not
receive direct sunshine, draft/rain or radiation from hot
substances. If such a place cannot be found, a roof or cover
should be prepared for protection.
• Avoid a location that is subject to heavy vibration.
• Select a location where atmospheric air is clean.
A.7 EC Directive Compliance
The product conforms to the requirements of the Low Voltage
Directive 73/23/EEC and EMC directive 89/336/EEC (as amended by
Directive 92/31/EEC), both as amended by Directive 93/68/EEC.
It conforms to following standards for product safety and
electromagnetic compatibility;
• EN61010-1: 2001 Safety requirements for electrical
equipment for measurement, control and laboratory use.
“Installation Category II” “Pollution Degree 2”
• EN61326-1: 1997, AI: 1998, A2: 2001 Electrical equipment
for measurement, control and laboratory use — EMC
requirements.
* The product mounted in a steel enclosure conforms to the
requirements of EMC directive.