CognitiveTPG CRx - Manual (Page 33)

29
Chapter 2: Getting Started
To initially set the media guides to the proper setting, try to push either guide to the
outside of the printer. If the guide does not move, lift up slightly on the green locking
tab until it stops in the upright position. Move the media guide to the outside of the
printer as shown in Figure 2-56.
Figure 2-56. Opening the Media Guides
NOTE: THE LOCK CAN BE REMOVED IF IT IS PULLED UP TOO HARD. IF THIS HAPPENS,
RE-INSERT THE LOCK IN THE MEDIA GUIDE.
Locate the media guide bar.
Figure 2-57. C Series Top View of Media Guide from Behind Printer
Device Use
A – Media guide (silver bar) Guides the labels through the printer
Before placing the roll in the printer, route the media, print side up, under the media
guide bar as shown in Figure 2-58.
A