CognitiveTPG CRx - Manual (Page 27)

23
Chapter 2: Getting Started
Figure 2-40. Media Guide Locking Tab
To initially set the media guides to the proper setting, try to push either guide to the
outside of the printer. If the guide does not move, lift up slightly on the green lock until
it stops in the upright position. Move the media guide to the outside of the printer as
shown in Figure 2-41.
Figure 2-41. Spread the media guides apart
NOTE: THE LOCK CAN BE REMOVED IF IT IS PULLED UP TOO HARD. IF THIS HAPPENS, RE-
INSERT THE LOCK IN THE MEDIA GUIDE.
Locate the media guide bar in the rear of the mechanism, indicated by the arrow in
Figure 2-42 below. The media must be placed under the media guide bar, or media
wandering can occur.