Clear-Com Logic-Maestro - Manual (Page 48)

Clear-Com Communication Systems
Eclipse Logic Maestro Instruction Manual
1 - 3 4
Crosspoint Priority
The crosspoint priority defines the priority at which the action is applied
to the crosspoints. For a crosspoint action to change the state of a
crosspoint it must be set to a priority higher than the crosspoint.
Figure 1-61: Crosspoint Action Priority
For example in order to override panel talk crosspoints at priority two
with a crosspoint action the action priority must be set to three or
higher.
Crosspoint Action Sources
Crosspoint action sources can be added to the list by dragging and
dropping devices from the Direct/Interfaces, Fixed Groups and Panels
lists onto the source list whether or not it is open. If the source list is
opened then dropping a new source onto an existing source will
replace it. If there are no items already assigned to the source list
then the list name will be highlighted in red. If there are items already
assigned the list will not be highlighted but instead will be surrounded
by a green box.
Figure 1-62: Crosspoint Action Source List
When the menu name is highlighted in yellow the item can be dropped
onto the list.