Clear-Com Logic-Maestro - Manual (Page 38)

Clear-Com Communication Systems
Eclipse Logic Maestro Instruction Manual
1 - 2 4
Right-clicking on ‘Add source...’ will display a menu allowing all the
ports or all the panels in the configuration to be added to the source
list.
Figure 1-42: Adding All Ports or Panels to Crosspoint Trigger
Sources in the list can be copied, cut, deleted or excluded by selecting
the required items from the list and right clicking to display the options
list. Multiple items on the list can be selected by holding down the Shift
key while selecting items.
Figure 1-43: Crosspoint Trigger Source Options
Items that are cut or copied can be pasted into other source or
destination lists. Deleting an item removes it from the list while the
‘Change to Excluded’ option allows a source to be excluded from
consideration when triggering an output. If a source is excluded it will
be displayed in red. If ‘All Ports’ is present in the source list this cannot
be excluded.
Crosspoint Trigger Destinations
Crosspoint trigger destinations can be added to the list by dragging
and dropping devices from the Direct/Interfaces, Fixed Groups and
Panels lists onto the destination list whether or not it is open. If the
destination list is opened then dropping a new destination onto an
existing destination will replace it. If there are no items already
assigned to the destination list then the list name will be highlighted in
red. If there are items already assigned the list will not be highlighted
but instead will be surrounded by a green box.