Clear-Com Logic-Maestro - Manual (Page 29)

Clear-Com Communication Systems
Eclipse Logic Maestro Instruction Manual 1 - 1 5
Control Output
Control outputs are used to activate outputs when the input state is
true. To set up a control output drag and drop a ‘Control O/P’ module
from the ‘Module Library’ onto the design pane.
Figure 1-22: Control Output Module
To add a control click on the ‘Controls’ menu to open it and display the
‘Add control’ item.
Figure 1-23: Control Output Menu
Drag and drop an item from the list of control labels onto the ‘Add
control’ item to add it to the list of controls that will be triggered by the
Control Output. The output control labels are set up in ECS by the
Control Manager and are usually General Purpose Outputs (GPOs).
These may be attaches to external devices such as relays to control
devices such as lights or door switches.
Figure 1-24: Adding a Control to the Control Output List
Alternatively control labels can be dragged and dropped directly onto
the unexpanded ‘Controls’ menu and they will be added to the controls
list.
Multiple control labels can be added to the control output module to
create a list of control labels that will be activated by the Control Output
module when it receives an active input.