Burkert Type 8696 - Manual (Page 39)

39
Electricalinstallation24VDC
10.2. Electrical installation with circular plug-in connector
DANGER!
Risk of electric shock!
• Before reaching into the device or the equipment, switch off the power supply and secure to prevent reactivation!
• Observe applicable accident prevention and safety regulations for electrical equipment!
10.2.1. Designation of the contacts Type 8696
Circular plug
M12 x 1, 8-pole
6
1
7
5
4
3
2
8
Figure 20: Circular plug M12 x 1, 8-pole
10.2.2. Connection of the positioner Type 8696
→
Connect the pins according to the model (options) of the positioner.
Input signals of the control center (e.g. PLC) - circular plug M12 x 1, 8-pole
Pin Wire color 13) Configuration external circuit / signal level
1
2
white
brown
Set-point value + (0/4 – 20 mA)
Set-point value GND
1
2 GND
+ (0/4 ... 20 mA)
5
6
grey
pink
Binary input +
Binary input -
5 + 0 ... 5 V (log. 0)
10 ... 30 V (log. 1)
6 GND
Table 14: Pin assignment - input signals of the control center - circular plug M12 x 1, 8-pole
Output signals to the control center (e.g. PLC) - circular plug M12 x 1, 8-pole
(required for analogue output option only)
Pin Wire color 13) Configuration external circuit / signal level
8
7
red
blue
Analogue position feedback +
Analogue position feedback GND
8
7 GND
+ (0/4 ... 20 mA)
Table 15: Pin assignment - output signals of the control center - circular plug M12 x 1, 8-pole
13)
The indicated colors refer to the connecting cable available as an accessory (919061)
english
Type 8696