Dynasonics TFXM Series Ultrasonic Multi-Channel Flow Meter - Manual (Page 70)

Rev. 8/02 -4. 3- TFXM
Click on the button labeled Configuration for updating flow
range, liquid, pipe and I/O operating information. The first screen
that appears after clicking the Configuration button is the BASIC
tab. See Figure 4.2 .
1. BASIC TAB—See Figure 4.2
??
General Units allows selection of either English (U.S.) or
Metric units of measure. If measurements of the pipe are to be
entered in inches, select English. If pipe measurements are to
be entered in millimeters, select Metric. It is recommended
that if the General Units are altered from those at instrument
startup, that the Download button be pressed on the lower
right-hand portion of the screen and that the TFXM have its
power cycled.
??
Standard Configurations contains the most popular
applications for the TFXM. The TFXM has been constructed
and configured at the Dynasonics factory for a specific pipe
size. If the Standard Configuration does not match the pipe
schedule or material, select the proper configuration from the
drop down list. If the pipe schedule is not listed or if the liquid
is not water, select Other on the drop down list and fill in the
proper information on the setup screen.
SOFTWARE UTILITIES
Using UltraLink
For
Configuration
Figure 4.2
Basic Tab