Dynasonics TFXM Series Ultrasonic Multi-Channel Flow Meter - Manual (Page 30)

Rev. 8/02
- 2.15 - TFXM
UltraLink Data Entry
The UltraLink Windows®-based software utility provides an effi-
cient means for entering piping and liquid parameters through
the use of pop-up window/pull-down menu structures. Data can
be entered into UltraLink, stored, later retrieved and downloaded
at the TFXM installation site (provided that UltraLink and TFXM
communications are not enabled at the time of data entry) or it
can be downloaded immediately to the TFXM meter (provided
that UltraLink and TFXM communications are enabled during
data entry).
To install UltraLink and establish communications with a PC,
please follow the instructions detailed in Section 4 of this man-
ual.
The system information required for entry into the UltraLink
package is identical to that required for Keypad Entry covered in
the previous section. See pages 2.3.
After initializing UltraLink, click on the button labeled Config.
The window shown in Figure 2.5 will appear. Enter the pipe and
liquid parameters into the appropriate data fields in the Basic
window. The correct transducer spacing will appear in the
Transducer - Spacing data field.
After all data fields have been entered Download to the TFXM
or File Save to a disk by clicking on the appropriate button in the
Config window. Download is not possible unless communica-
tions are enabled between the TFXM and UltraLink. Communi-
cations are enabled when a green OK is indicated in the lower
right-hand COMM: status box. If communications are not en-
abled, please review the documentation that is detailed in Sec-
tion 4 of this manual.
PART 2 - TRANSDUCER POSITIONING
UltraLink Entry