Datamax-O'Neil Class Series Programmer’s Manual - Manual (Page 49)

System-Level Command Functions
Class Series Programmer’s Manual 35
STX Z Print Configuration Label
This command causes the printer to produce a Database Configuration Label. To capture all printed
information, use the labels as wide as the maximum print width (see Appendix K) and at least four
inches (102 mm) long.
Syntax:
Z
Printer response:
FRI SEPTEMBER 026, 1997 19:29 244
VER: E4304 - 04.06 08/24/01
BOOT 83-2329-04A
CODE 83-2325-04F
FONT 83-2337-01A
CPLD 59-2157-01C
SYSTEM RAM CHECKS____ GOOD
SYSTEM RAM SIZE___ 2016 KBYTES
SYSTEM RAM AVAIL__ 1264 KBYTES
REG POWER SUPPLY__ NO
INPUT VALUES
PAPER_____________ 255
DARKNESS__________ 131
TRAN______________ 255
REFL______________ 149
RIBM______________ 87
THR_______________ 48
24V_______________ 223
DIRECT THERMAL
COMMUNICATIONS NOT DETECTED
9600,8,N
EDGE
SOP ADJUST________ 128
PRESENT ADJUST____ 128
TOF LOW___________ 0
TOF DELTA_________ 10
TOF GAIN__________ 10
OOS MAXVOLT_______ 2
COUNTER INFORMATION
ABSOLUTE VALUES 9-18-1999
LENGTH____ 773 INCHES
TIME______ 20 HOURS
RESETTABLE VALUES 9-22-1999
LENGTH____ 576 INCHES
TIME______ 10 HOURS
MEMORY CONFIGURATION
INTERNAL MODULE______ 128
SCALABLE FONTS_______ 64
LABEL SIZE 0410:02218 IN
 Note: Printed information will vary according to printer, model, firmware version, and options.
STX z Pack Module
This command causes the printer to reclaim all storage space associated with all deleted files on the
specified module (see X and x).
Syntax:
zm
Where:
m
- The module identification character, see Appendix K.