Datamax-O'Neil Class Series Programmer’s Manual - Manual (Page 123)

Class Series Programmer’s Manual 109
Label Formatting Command Functions
Introduction
The L command switches the printer from the System-Level Processor to the Label Formatting
Processor. All commands following the L are interpreted as label formatting commands, and can
be used to override default parameter values. Selectable parameter value defaults may be also reassigned
via the Setup Menu, as defined in the corresponding Operator’s Manual. Label formats that contain no
commands overriding printer default values will assume those defaults.
:
Set Cut By Amount
This command allows a predetermined number of labels to be printed before a cut is initiated. This
feature is useful when it is necessary to print an uncut strip of labels. Between 1 and 9999 labels may
be printed before a cut is made. The amount must be smaller than the quantity of labels printed.
Syntax: :nnnn
Where:
nnnn
- Is a four digit decimal number indicating the number of labels to
be printed before a cut is performed.
Sample: L
:0005
141100001000100SAMPLE LABEL
Q0021
E
The sample instructs the printer to make a cut after 5, 10, and 20 labels have been printed. Label 21
will be cut at the start of a subsequent label format (batch) unless a default (cut by amount) greater
than one has been entered.
 Note: The cutter must be enabled and all mechanism interlocks closed for operation.