Soh b toggle pause – Datamax-O'Neil Class Series Programmer’s Manual User Manual
Page 25
Immediate Command Functions
Class Series Programmer’s Manual
11
Where:
Possible Values
Interpretation
Byte Transmit Sequence
a
-
Y/N
Y
=
Interpreter busy (imaging)
1
b
-
Y/N
Y
=
Paper out or fault
2
c
-
Y/N
Y
=
Ribbon out or fault
3
d
-
Y/N
Y
=
Printing batch
4
e
-
Y/N
Y
=
Busy printing
5
f
-
Y/N
Y
=
Printer paused
6
g
-
Y/N
Y
=
Label presented
7
h
-
N
N
=
Always No
8
-
:
:
=
Always :
9
i
-
Y/N
Y
=
Cutter Fault
10
j
-
Y/N
Y
=
Paper Out
11
k
-
Y/N
Y
=
Ribbon Saver Fault
12
l
-
Y/N
Y
=
Print Head Up
13
m
-
Y/N
Y
=
Top of Form Fault
14
n
-
Y/N
Y
=
Ribbon Low
15
o
-
Y/N
Y
=
N (reserved for future)
16
p
-
Y/N
Y
=
N (reserved for future)
17
Table 3-1: ASCII Status Bytes
SOH B
Toggle Pause
This command toggles the printer’s paused state between on and off. (This is the same function
achieved by pressing the PAUSE Key on the printer.)
Syntax:
Sample:
Printer Response:
This command will illuminate the Paused/Stop Indicator and/or indicate
PAUSED on the LCD or graphics display panel, suspend printing, and wait
until one of the following occurs:
The
The PAUSE Key is pressed.
Upon which the printer will turn the Paused/Stop Indicator ‘Off’ and/or
remove PAUSED from the LCD or graphics display panel, then resume
operation from the point of interruption. (If the Receive Buffer is not full,
an