Datamax-O'Neil Class Series Programmer’s Manual - Manual (Page 41)

System-Level Command Functions
Class Series Programmer’s Manual 27
STX T Print Quality Label
This command instructs the printer to produce a Print Quality label, a format comprised of different
patterns and bar codes useful in printer setup. (On display-equipped models, this is also one of the
Quick Test formats.) To capture all printed information, use the labels as wide as the maximum print
width (see Appendix K) and at least four inches (102 mm) long.
Syntax: T
Printer response (dot
patterns may vary):
STX t Test DRAM Memory Module
This command tests the DRAM module. The printer returns a one-line message stating the module
condition (no message is returned if a module is unavailable).
Syntax: t
results - Test results given as ‘Good’ or ‘Bad’.
Non-Display Models: The printer must be in Test Mode for the command to function. To enable the
Test Mode see the KD command.
Printer response format: axxxK results
Where: a - 2 = Slot B
xxx
- Module size in Kbytes
Display-Equipped Models: The printer must have Feedback Characters enabled for this command to
function. Feedback Characters can be enabled via the menu (see the Operator’s Manual for additional
information).
Printer response format: Module A: xxxxK DRAM Testedresults
Module B: xxxxK DRAM Testedresults
Module D: xxxxK DRAM Tested results
Where:
xxxx
- Module size in Kbytes.