Datamax-O'Neil Class Series Programmer’s Manual - Manual (Page 133)

Label Formatting Command Functions
Class Series Programmer’s Manual 119
r Recall Stored Label Format
This command is used to retrieve label formats stored on a memory module.
Syntax: rnn...n
Where:
nn…n
- Is a label name, up to 16 characters in length.
The samples below explain different ways to recall and print a label format. (To view a memory
module’s directory of label formats use the W command.)
String Sent: Printer Interpretation:
Sample 1: L
rTEST
Q0002
E Begin label format
Retrieve format named TEST
Quantity requested = 2
Terminate formatting and print
Sample 2:
L
rTEST
X
G
Begin label format
Retrieve format named test
Terminate formatting
Print
Sample 3: L
D11
PO
SO
rTEST
E Begin label format
Dot size = 1x1
Print speed O
Feed speed O
Retrieve format named test
Terminate formatting and print
S Set
Feed Speed
This command controls the rate at which the label is moved through non-printed areas. The setting
remains unchanged unless another feed speed command is received or until the printer is reset.
Syntax: Sa
Where: a - Is a single alpha character representing a speed; see Appendix
L for valid ranges.
Sample: L
SE
141100001000100LABEL1
E
L
1411000010001000LABEL2
E
The sample sets the feed speed to 3 inches per second (76 mmps), and prints two labels. The feed
speed for the second label is the same as the first.