ALLIED Vision Technologies Guppy PRO F-503 - Manual (Page 266)

Configuration of the camera
Guppy PRO Technical Manual V4.0.0
264
Software feature control (disable LED)
The software feature control register allows to enable/disable some features
of the camera (e.g. disable LED). The settings are stored permanently within
the camera and do not depend on any user set.
Disable LEDs
• To disable LEDs set bit [17] to 1.
• To disable LEDs in SmartView:

Adv3 tab, activate Disable LED functionality check box.
The camera does not show any more the status indicators during normal oper-
ation:
Examples:
• Power on is not shown
• Isochronous traffic is not shown
• Asynchronous traffic is not shown
Register Name Field Bit Description
0xF1000640 SWFEATURE_CTRL Presence_Inq [0] Indicates presence of this feature
(read only)
BlankLED_Inq [1] Indicates presence of Disable LEDs
feature.
--- [2..15] Reserved
--- [16] Reserved
BlankLED [17] 0: Behavior as described in Chapter
Status LEDs on page 72.
1: Disable LEDs. (Only error codes
are shown.)
--- [18..31] Reserved
Table 145: Advanced register: Software feature control (disable LEDs)
Note

During the startup of the camera and if an error condition is
present, the LEDs behave as described in Chapter Status LEDs
on page 93ff.