Atec Agilent-PNA-X Series - Manual (Page 41)

41
General Information
 Miscellaneous Information
 Front Panel
 Rear Panel
 Environment and Dimensions
Table 32. Miscellaneous Information
Description Supplemental Information
System IF Bandwidth Range 1 Hz to 15 MHz, nominal (7 MHz, 10 MHz, and 15 MHz IFBWs are available ONLY
with FW A.09.42 and later, and with DSP version 5)
CPU Intel 2.0 GHz Core i7. Note: Some instruments may have a different CPU.
For the latest information on CPUs and associated hard drives, visit:
http://na.tm.agilent.com/pna/hdnumbers.html
LXI Class C (only applies to N5241A, N5242A, and N5249A models that are shipped with
firmware revision A.08.20 and higher)
Table 33. Front Panel Information, All Options
Description Typical Performance
RF Connectors
Test Ports 3.5 mm (male), 50 ohm (nominal), 0.002 in. Center Pin Recession (characteristic)
Jumpers 3.5 mm (female) connectors with SMA (male) jumper cables
USB 2.0 Ports – Master (4 ports)
Standard Compatible with USB 2.0
Connector USB Type-A female
Display
Size
26.3 cm (10.4 in) diagonal color active matrix LCD; 1024 (horizontal) X 768 (vertical)
resolution
Refresh Rate Vertical 60 Hz; Horizontal 46.08 kHz
Pixels
A display is considered faulty if:
• A complete row or column consists of “stuck” or “dark” pixels.
• More than six “stuck on” pixels (but not more than three green) or more than 0.002% of
the total pixels are within the LCD specifications.
• More than twelve “dark” pixels (but no more than seven of the same color) or more than
0.004% of the total pixels are within the LCD specifications.
• Two or more consecutive "stuck on" pixels or three or more consecutive "dark" pixel (but
no more than one set of two consecutive dark pixels)
• “Stuck on” “dark” pixels are less than 6.5 mm apart (excluding consecutive pixels)