Atec Agilent-PNA-X Series - Manual (Page 18)

18
Uncorrected System Performance
Specifications apply to following conditions:
 Over environmental temperature of 25 °C ±5 °C, with less than 1°C variation from the calibration temperature.
 Cable loss not included in Transmission Tracking.
 Crosstalk measurement conditions: normalized to a thru, measured with shorts on all ports, 10 Hz IF
bandwidth, averaging factor of 8, alternate mode, source power set to the specified maximum power.
 With option 029, port 1 impedance tuner switch is in external position and port 2 noise receiver switch is in
noise receiver position unless specified. Refer to Options 200, 219, 224, 400, 419, 423 for performance of Option
029 Port 1 with impedance tuner switch in internal position, Port 2 noise receiver switch in normal position,
Ports 3 and 4.
Table 7a. Directivity (dB)
Description Specification Typical
Options
200, 219, 224, 400,
419, 423
Option 029
Options
200, 219, 224, 400,
419, 423
Option 029
All Ports Ports 1, 2 All Ports Ports 1, 2
10 MHz to 50 MHz 16 16 23 22
50 MHz to 500 MHz 24 24 28 28
500 MHz to 3.2 GHz 24 24 32 32
3.2 GHz to 8.5 GHz 23 23 25 25
8.5 GHz to 10 GHz 23 23 25 25
10 GHz to 13.5 GHz 16 16 22 20
13.5 GHz to 16 GHz 16 16 22 20
16 GHz to 20 GHz 16 15 22 20
20 GHz to 24 GHz 16 15 22 20
24 GHz to 26.5 GHz 16 15 22 20