Atec Agilent-PNA-X Series - Manual (Page 21)

21
Test Port Output
See Block diagrams for all models and options beginning on page 59.
With option 029, port 1 noise tuner switch is in internal position and port 2 noise receiver switch is in normal position
unless specified.
Table 8. Frequency Information, All Options
Description Specification (dB) Typical (dB)
N5249A Frequency Range 10 MHz to 8.5 GHz --
N5241A Frequency Range 10 MHz to 13.5 GHz --
N5242A Frequency Range 10 MHz to 26.5 GHz --
Frequency Resolution 1 Hz --
Frequency Accuracy +/- 1 ppm --
Frequency Stability --
+/-0.05 ppm, -10° to 70° C 1
+/-0.1 ppm/yr maximum 2
1 Assumes no variation in time.
2 Assumes no variation in temperature.
Table 9a. Maximum Leveled Power (dBm), Options 200 or 400
Description Specification Typical
Ports 1, 3 1 Ports 2, 4 1 Ports 1, 3 1 Ports 2, 4 1
Filtered
Mode 2
Hi Power
Mode 2
Filtered
Mode 2
Hi Power
Mode 2
10 MHz to 50 MHz 8 13 13 10 19 17
50 MHz to 500 MHz 10 13 13 11 21 20
500 MHz to 3.2 GHz 10 10 13 12 13 18
3.2 GHz to 8.5 GHz 13 13 13 20 20 19
8.5 GHz to 10 GHz 13 13 13 20 20 19
10 GHz to 13.5 GHz 13 13 13 17 17 16
13.5 GHz to 16 GHz 13 13 13 17 17 16
16 GHz to 20 GHz 13 13 10 16 16 12
20 GHz to 24 GHz 12 12 7 15 15 11
24 GHz to 26.5 GHz 5 5 2 11 11 7
1 Either port can be used as the source port.
2 In Filtered Mode, the signal path goes through filters to minimize harmonics below 3.2 GHz. In Hi Power Mode, the
signal bypasses the filters to maximize output power.