Atec Agilent-E8364C - Manual (Page 60)

Source
Switch/splitter/leveler
Reference
receiver
Reference
receiver
Measurement
receivers
Cplr
arm
Bias-tee
Source attenuator 1
A
Bias-tee
Source attenuator 1
B
R1 R2
10 dB steps 10 dB steps
Receiver
attenuator 2
Rcvr B
in
Rcvr A
in
Cplr
arm SRC
out
Cplr
thru Source
out
Rcvr R2
in
Cplr
thru SRC
out
Rcvr R1
in
Source
out
Option 081
Fully optioned (Options 014, UNL, 016, 080, 081)
Aux RF out (2-20 GHz) Aux LO out (2-20 GHz)
V
tune
YIG source
Multipliers (1, 2, 4)
f
Phase-locked loop
Offset LO
Offset receiver
Option 080
Option
081
Option 014
Option UNL
Option 016
ADC
R1
External IF in
A
External IF in
ADC
IF gate
IF gate
ADC
R2
External IF in
B
External IF in
ADC
IF gate
IF gate
Multipliers (1, 2)
Front
Rear Option H11
LO X
X
Option H11* Option H11*
Option H11* Option H11*
Option
UNL
Test port 1 Test port 2
8.33 MHz
reference
*Option H11 notes:
• IF-gate controls
and external IF
inputs are accessed
on rear panel
• IF gates are
enabled
with
Option H08
• External IF input
frequency
is
8.33 MHz
Fully optioned pulse, antenna, or mm-wave configuration (Options 014, UNL, 016, 080, 081, H11)
1. Source attenuator for E8362/3/4C is 60 dB in 10 dB steps. Source attenuator for E8361C is 50 dB in 10 dB steps.
2. Receiver attenuator for E8362/3/4C is 35 dB in 5 dB steps. Receiver attenuator for E8361C is 50 dB in 10 dB steps.
60