Atec Agilent-E8364C - Manual (Page 51)

51
Microwave PNA Series
Measurement throughput summary
Cycle time vs. IF bandwidth 1 Cycle time vs. number of points 1
Instrument state: preset condition, 201 points, Instrument state: preset condition, 35 kHz IF
CF = 28 GHz, Span = 100 MHz, correction off. Add bandwidth, CF = 28 GHz, Span = 100 MHz,
21 ms for display on. Cycle time includes sweep correction off. Add 21 ms for display on. Cycle
and re-trace time. time includes sweep and re-trace time.
Cycle time (ms) 1,2
Number of points
201 401 1601 16,001
Start 28 GHz, stop 30 GHz, IFBW = 35 kHz
Uncorrected and one-port cal 12 19 55 503
Two-port cal 29 44 124 1112
Start 10 MHz, stop 10 GHz, IFBW = 35 kHz
Uncorrected and one-port cal
86 93 121 583
Two-port cal 179 199 267 1301
Start 10 MHz, stop 20 GHz, IFBW = 35 kHz
Uncorrected and one-port cal
126 130 153 597
Two-port cal 264 275 335 1321
Start 10 MHz, stop 40 GHz, IFBW = 35 kHz
Uncorrected and one-port cal
185 190 213 621
Two-port cal 382 401 459 1374
Start 10 MHz, stop 50 GHz, IFBW = 35 kHz
Uncorrected and one-port cal
210 216 243 643
Two-port cal 436 450 522 1405
Start 10 MHz, stop 67 GHz, IFBW = 35 kHz
Uncorrected
244 254 300 645
Corrected 502 524 591 1423
IF bandwidth (Hz) Cycle time (ms) Cycle time (ms)
Option 080 enabled
40,000 11 100
35,000 12 101
30,000 13 102
20,000 16 106
10,000 30 127
7,000 38 138
5,000 50 152
3,000 74 182
1,000 274 326
300 694 782
100 1905 2054
30 6091 6355
10 17916 18372
Number of points Cycle time (ms)
3 6
11 6
51 7
101 9
201 12
401 18
801 30
1601 55
16,001 497
1. Typical performance.
2. Includes sweep time, retrace time and band-crossing time. Analyzer display
turned off with DISPLAY:ENABLE OFF. Add 21 ms for display on.
Data for one trace (S11) measurement.