Alpha Technologies Cordex Controller Ver.3.1x - Manual (Page 41)

39 0700015-J0 Rev B
6.2 Converters
This menu category consists of converter alarms and controls. Parameters can be set/accessed such as
output voltage, OVP, high/low voltage alarms, and start delay.
The converter defaults are based on the system voltage of either 24 or 48 VDC.
At present, the converter software does not support:
• Two types of converters simultaneously
• 12, 125, and 220 VDC systems.
Other features include:
Active voltage control Inventory update
Converter locate Loadsharing
Firmware upgrade Major and minor alarms
6.2.1 Converter Report
This feature provides the user with a list report (see 4.7.2, Figure 17) of all acquired converters in the
system. The first column lists the serial numbers of the converters. The report then displays the output
current of each converter under the Amps column (or toggle for % of maximum output) and the number
of active alarms under the Alarms column (if that converter is issuing an alarm). The right most column
displays the number of settings out of tolerance.
Select a converter and tap View Details to produce another list showing details of the entire converter
alarms and settings that are out of tolerance.
6.2.2 Configure Settings
This feature allows the user to configure settings (via menu items) for all of the acquired converters in the
system; such as:
Output Voltage Start Delay
OVP Enable CL Alarm
Input Voltage Shutdown Input Voltage Restart
6.3 Rectifiers
This menu category consists of rectifier alarms and controls. Parameters can be set/accessed such as
float/equalize voltages, high/low voltage alarms, and start delay.
6.3.1 Rectifier Report
This feature provides a list report (see 4.7.2, Figure 17), of all acquired rectifiers in the system. The first
column lists the serial numbers of the rectifiers. The report then displays the output current of each recti-
fier under the Amps column (or toggle for % of maximum output) and the number of active alarms under
the Alarms column (if that rectifier is issuing an alarm). The right most column displays the number of
settings out of tolerance (OOT per web interface).
Select a rectifier and tap
View Details to produce another list showing details of the entire rectifier alarms
and settings that are out of tolerance.
6.3.2 Configure Settings
This feature allows the user to configure settings (via menu items) for all of the acquired rectifiers in the
system.