Alpha Technologies Cordex Controller Ver.3.1x - Manual (Page 35)

33 0700015-J0 Rev B
5.7.3 Silence all Alarms
Click the speaker icon to acknowledge active alarms. This may silence the buzzer and revert the alarm
relay to normal state depending on the global alarm configuration.
To configure global alarm parameters, select
Alarms > Global Alarm Configuration from the main menu.
5.7.4 Configure Alarms
Select Alarms > Configure Alarms from the main menu. See section 6.6 for a description of the alarm
parameters.
Ensure that the operating levels (e.g., input/output voltage, converter voltage, etc.) are within the operat-
ing parameters of the alarm and control thresholds.
Figure 27 — Configure Alarms – Web Interface
5.8 Converters
Select Converters > View Live Status for status report and alarms.
Select Converters > Configure Converters to set the rectifier parameters. Refer to section 6.2for a descrip-
tion of the parameters.
5.9 Rectifiers
Select Rectifiers > View Live Status for status report and alarms.
Select Rectifiers > Configure Rectifiers to set the rectifier parameters. Refer to section 6.3 for a descrip-
tion of the parameters.
Other menu options are Inventory Update, Power Save and Rectifier Phase Mapping—all of which are
described in section 6.3.
5.10 Inverters
Select Inverters > View Live Status for status report and alarms. Refer to Table A for menu options and
section 6.4 for a description of the parameters.
5.11 Battery Mode and Temp Comp Settings
Select System> Select Voltage Mode to change voltage mode. Refer to section Figure 3 for a description
of all battery parameters.
Figure 28 — Select Voltage Mode – Web Interface