Alpha Technologies Cordex Controller Ver.3.1x - Manual (Page 39)

37 0700015-J0 Rev B
6.1.3 Set ADIO Module Number
The Supervisor can select and map the order number in which CAN-enabled system devices, such as
Battery Cell Monitor (BCM), are to appear in the CXC menus; shown in the examples below:
When replacing ADIO modules, assign the new identical device with the same ADIO module number of
the old device. This numbering preserves the functionality of any equations that use signals originating
on the old device.
6.1.4 Site Information
Figure 31 — Firmware upgrade procedure
Select module
for mapping; e.g.
module 2
The module number
is important when any
of the signals from an
ADIO device is used for
custom signals or data
logging.
Discard changes
and return to previ-
ous screen
Identical fields
exist in the LCD
for the entry and
display of site
information.
Tap arrows to in-
crease or decrease
value as required
Accept changes
and return to previ-
ous screen
Figure 32 — ADIO Modules and Swap Modules windows
Figure 33 — Site Information and Contact Information windows – Web
7. Repeat the steps above choosing Shunt MUX as required.
1-888-462-7487