Alpha Technologies Cordex Controller Ver.3.1x - Manual (Page 107)

105 0700015-J0 Rev B
9.1.1 Support for CXC with No LCD Display
Some CCXs have a 4-digit display or no LCD for system monitoring. System setup and management is
performed exclusively from the web interface. To establish remote communications, begin setup as fol-
lows:
Perform steps 1 through 6 in the preceeding section.
Reboot the CXC (see 6.9.3.1): press and hold the front panel reset button for three seconds. The unit
beeps three times, IP is reset (to 10.10.10.201) and DHCP is disabled. The settings are saved and the
unit then reboots/resets.
Perform steps 14 through 16 in the preceeding section.
9.2 PPP Serial Data Connection
The user must set up a “direct cable connection” for the workstation to be connected (with a null modem
cable) to the CXC Craft port (address 10.10.10.203). Follow the example below, shown for Windows ®
2000 (and similar in Windows ® XP).
9.2.1 Starting Networking Wizard
Select Start menu, Settings , and then select Network and Dial-Up Connections :
A new window opens, similar to Figure 130. Double-click the Make New Connection icon to start the Net-
work Connection Wizard.
Figure 129 — Starting networking wizard
Figure 130 — Make New Connection icon