Extron Electronics VTG 400D_400 DVI User Guide - Manual (Page 66)

VTG 400D/400 DVI • Appendix A-2
Appendix
Specifications
Video signal characteristics
Dot clock ....................................... 200 MHz (max.)
Pixel clock accuracy ..................... 100 ppm
Horizontal frequency range (factory defaults)
15 kHz to 131 kHz
Vertical frequency range (factory defaults)
30 Hz to 120 Hz
Rise/fall time
NTSC, PAL ....................... 140 ns
All other signal rates ....... <4 ns
Video output
Number/signal type ................... 2 RGBHV, RGBS, RGsB, RsGsBs
1 component video
1 S-video
1 composite video (NTSC/PAL)
1 HD-SDI (SMPTE 292M), SDI (SMPTE 259M-C) – VTG 400D only
1 DVI-D (single link) – VTG 400 DVI only
Connectors .................................... 1 x 5 female BNC (RGB)
1 female 15-pin HD (RGB)
1 x 3 female BNC (component video)
1 female 4-pin mini DIN (S-video)
1 female BNC (composite video)
1 female BNC (SDI/HD-SDI) – VTG 400D only
1 female DVI-I (DVI-D) – VTG 400 DVI only
Nominal level ............................... 1 Vp-p for RsGsBs, Y of component video and S-video, and for composite
video
0.7 Vp-p for RGB and for R-Y and B-Y of component video
0.286 Vp-p (burst) for C of NTSC S-video, 0.300 Vp-p (burst) for C of PAL
S-video
Minimum/maximum levels ...... 0.0 V to 1.0 Vp-p
Impedance .................................... 75 ohms
Resolutions ................................... Computer (VGA–WQXGA), video (NTSC, PAL), HDTV, 16:9 high
resolutions, and custom resolutions (user-defined)
Return loss .................................... -30 dB @ 5 MHz
DC offset ....................................... 0 ±5 mV for RGB and component video,
0 ±5 mV for NTSC S-video and composite video
14 mV ±5 mV for PAL S-video and composite video
Sync
Output type .................................. RGBHV, RGBS, RGsB, RsGsBs (for RGB signals)
Tri-level on Y, R-Y, B-Y channels (component video 720p, 1080i, 1080p)
Bi-level on Y channel (for all other component video rates)
Standards ...................................... NTSC, PAL, SMPTE 170M, SMPTE 274M, SMPTE 293M, SMPTE 295M,
SMPTE 296M
Output level .................................. 0.3 Vp-p for RGsB, RsGsBs, component video (bi-level sync)
0.6 Vp-p for RGsB, RsGsBs, component video (tri-level sync)
TTL: 5.0 Vp-p, unterminated for RGBHV, RGBS
Output impedance ....................... 75 ohms
Max. rise/fall time ....................... 5 ns (TTL sync)
Polarity .......................................... Positive or negative (scan rate/signal dependent)